How To Install a Saddle Valve for Your Humidifier or Refrigerator

This time of yr inside the Midwest deliver many changes to our lives. Changing the clocks way leaving and returning home within the dark. Another trade is the indoor air first-class in our homes. The bloodless dry air of wintry weather reminds us it’s time to turn on the humidifier.

I simply received a call from a relative who just became on the water supply to the humidifier and it become now leaking. After a pair questions, observed by using a suggestion the trouble changed into remedied in a couple of minutes. This phone name got me to considering the ones difficult saddle valves that supply water to so many humidifiers and ice makers.

Safety first, NEVER EVER use a saddle valve for any form of fuel, best water. A saddle valve gets its name from the way it looks, like a saddle on a horse. They are an less expensive way to get water to humidifiers, ice makers, etc. There are several slightly exceptional versions however all have the equal components and are mounted the same.

You can be operating on a live water pipe so before you begin discover the water shutoff in your home, just in case you need to fast flip the water off.

Take a take a look at the photograph underneath and carefully take a look at the elements of the valve I have categorised. The saddle is the part that wraps across the pipe, and is held collectively by way of 2 screws or bolts. The seat of the valve is in which the needle valve (or stem valve) travels thru and punctures the pipe. Between the seat and the pipe is a rubber gasket that seals the area around the needle valve puncture. The needle valve works nicely on copper and plastic pipe, but now not very well on galvanized pipe.

The first step to install the valve is to easy the pipe all of the way around where the valve goes to be established, usually with a mild sanding. Next position the valve across the pipe, with the output connection and top of the needle valve in a role that you may effortlessly get entry to each. Take into consideration wherein the output line has to run to. When positioning the saddle valve across the pipe be careful to ensure the gasket is seated well. One trick is to screw the needle valve down till it barely touches the pipe, permitting you to properly center the gasket. When you have the gasket nicely seated tighten the saddle valve, calmly, alternate with a couple turns on every aspect until correct and snug.

Next connect the output line to the saddle valve, leaving plenty of greater length and region the end in a bucket or floor drain. You are now equipped to show at the water. Slowly flip the needle valve so it pierces the pipe. When you cannot turn it by means of hand anymore slowly back twist it backwards. Water have to now start to pop out of the stop of the output pipe. If not then repeat turning it in to pierce the pipe.

Once you see water coming out the output pipe near the valve and join the output line for your humidifier, ice maker, etc. Now turn it on one final time, checking for leaks.

If it does leak from the needle valve stem, you then wishes to very slowly tighten the nut (packing nut) that surrounds the needle valve (check with photograph). If it leaks from the gasket area, test to make sure the screws holding the saddle valve to the pipe are tight.

A common exercise is to show the saddle valve off whilst you switch off the humidifier within the spring. If you do that, it is probably inside the fall when you turn it back on it’s going to leak from the needle valve stem. Not to fear, just flip the packing nut barely until the leaking stops

Comments are closed.